Elko eLAN-RF-003 Instrukcja Obsługi Pobierz pdf (Strona 47)

474





 

Press 2x = set

the “light scene” function

Press 5x = set

the “sunrise” function

Mount the receiver in an installation box, under a light or into a switchboard,

according to the design of the receiving actuator.

Use a suitable tool to press the

program button on the receiver

for more than 1 second. The

receiver LED will start to  ash in

0.5-second intervals.

The  ashing of the receiver indi-

cates that it is in program mode

and is ready to receive signals

from any transmitter button

with a selected program.

By pressing the transmitter button repeatedly, save the selected program. The number

of times the button is pressed (1x to 7x) corresponds to each respective function (see the

chart below). Signal transmission is indicated by the  ashing transmitter LED.

The receiving actuator con rms the acceptance of the command when its LED goes dark

for a short moment. Step 3 can now be repeated to program the remaining button posi-

tions or other transmitters.

Program functions can be set to any transmitter position - wireless wall switch button or

Keychain. Each receiver can be controlled by up to 32 channels (1 channel is represented by

1 button on the wireless wall switch button, keychain or detector). The transmitter may be

connected to more receivers to control an unlimited number of receivers with functions to

which it is programmed and which are within the range of the RF signal.

Finish the program mode by pressing the re-

ceiver button. The red LED will stop  ashing.

Press and hold the receiver button again for

more than 5 seconds to delete one actuator

from memory. The LED will start to  ash in

1-second intervals. Now press the button co-

rresponding the transmitter whose function

you want to delete. Press the receiver program

button to return the actuator to the original

mode.

Actuator program selection

Number of pressing

the transmitter

button

Multifunction receivers

DimmerSwitch

Press 1x Button Scene 1

Press 2x Switch on Scene 2

Press 3x Switch oﬀ Scene 3

Press 4x Impulse relay Scene 4

Press 5x Delayed return Sunrise

Press 6x Delayed start Sunset

Press 7x ON/OFF

Easy and quick program setting

Mount the receiver in an installation box, under a light or into a switchboard,

PROGRAMMING OF WIRELESS WALL SWITCH BUTTON AND SWITCHING ACTUATOR

PROGRAMMING OF RF TOUCH CONTROL UNIT

Keep in mind that the radio signal range for RF installati-

ons depends on the building structure, materials used and

the manner of unit location in the area.

Step 1 – Location of RF Touch and RF units

For radio frequency signal penetration through various construc-

tion materials, see the chart on page 48.

- name of the device you want to control (for creating a menu)

- names of units (for correct classification into a group,

e.g. RFSA-61B)

- unit addresses (for actuator identification, e.g. 00150A)

The Installation Form is included at the end of the Manual

Step 2 – Complete the Installation Form

Create the list of controlled device names in Settings / Menu

(Create name).

Step 3 – Menu setting (create names)

The programming of RF units with RF Touch is conducted

in Settings / Programming.

Step 4 – Programming

Name

Address

e.g.RFSA-61B

e.g.00150A

0.5

1 2 ... 42 43 44 45 46 47 48 49 50 51 52

Komentarze do niniejszej Instrukcji

Brak uwag

Elko eLAN-RF-003 Instrukcja Obsługi Strona 47

Komentarze do niniejszej Instrukcji